Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Switches
3-38 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: d-ch3
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:50 PM
Setting Up Dual Redundant Controllers (Transparent Failover
Configurations)
The following text provides instructions for setting up a multiple cluster
configuration with dual redundant controllers (transparent failover).
Setting Up an Additional Cluster with a Single Storage Subsystem
To set up an additional cluster with a single storage subsystem:
1. Set up the first cluster according to the instructions starting on page 3-5.
2. Follow the cluster installation instructions in this chapter to set up the second,
third, or fourth cluster with the important exceptions included in Table 3-11.
Table 3-11: Setting Up the Second Cluster (Dual Controller
Configuration)
Chapter 3 Section Heading Page Action
Setting Controller to No Failover 3-12 Omit
Disabling the Command Console LUN 3-13 Omit
Setting Port Topology 3-14 Omit
Discovering Devices 3-14 Execute section if additional
drives are added.
Verifying Controller Properties 3-17 Omit
Verifying Access 3-21 Step 12: Delete only the
connections that have
!NEWCONXX. Leave the
connection paths you
renamed previously.
Only add the connection
names that need access to
the new logical units.