Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Switches
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 3-37
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: d-ch3
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:50 PM
Table 3-9: Setting Up the Second Cluster
(Single Controller Configuration, Single Storage Subsystem)
continued
Chapter 3 Section Heading Page Action
Verifying Controller Properties 3-17 Omit
Verifying Access 3-21 Step 12: Delete only the
connections that have
!NEWCONXX. Leave the
connection paths you
renamed previously.
Only add the connection
names that need access to
the new logical units.
Setting Up Dual Storage Controllers 3-29 Omit
Setting Up Additional Clusters and Storage Subsystems
NOTE: When installing additional clusters and additional storage subsystems, minimize
rebooting the existing cluster nodes because connection paths will be established on the new
storage subsystem for all servers that reboot and rescan for all available logical units. This can
become cumbersome when trying to establish permanent connection path names for the new
servers.
1. Set up the first cluster according to the instructions starting on page 3-5.
2. Follow the cluster installation instructions in this chapter to set up the second,
third, or fourth cluster with the important exceptions included in Table 3-10.
Table 3-10: Setting Up Additional Clusters and Storage Subsystems
Chapter 3 Section Headings Page Action
Setting Up Dual Storage Controllers 3-29 Omit