Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Switches
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 3-33
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: d-ch3
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:50 PM
Setting Up a Single Cluster with an Additional Storage Subsystem
(Single Controller Configuration)
1. Set up the cluster with the first storage subsystem according to the instructions in
this chapter starting on page 3-5.
2. Follow the cluster installation instructions in this chapter to set up the second,
third, or fourth storage subsystem, with the important exceptions included in
Table 3-6.
Table 3-6: Setting Up a Single Cluster with an Additional Storage
Subsystem (Single Controller Configuration)
Chapter 3 Section Heading Page Action
Setting Up the Servers 3-5 Omit
Updating Switch Firmware 3-10 Omit
Combining Switch Models in a Cluster
Configuration
3-11 Omit
Installing the StorageWorks Command
Console Client
3-11 Omit
Installing the Adapter Driver 3-14 Omit
Running the Fibre Channel Fabric Setup Utility 3-16 Omit
Cluster Installation and Verification 3-26 Omit
Setting Up Dual Storage Controllers 3-29 Omit
NOTE: Refer to Chapter 5 for information on adding shared storage.