Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
2-38 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
Table 2-10: Setting Up the Second Cluster (Multibus Failover Configuration)
continued
Chapters 2 and 4 Section Heading Page Action
Verifying Controller Properties 2-13 In Table 2-4, use the following text for
Host Ports:
• Host Port 2 Requested Topology:
Loop Hard
• Host Port 2 Requested Port Address: 72
• Host Port 2 Actual Port Address: 72
Configuring a Storageset 2-16 Use the following text for step 9: Enter the
virtual disk name. Windows NT recognizes
D100 through D107 for the second cluster if
Large LUN Utility is not installed.
Volume Creation 2-21 Follow the instructions in this section to assign
the connection paths for the primary path of
the second cluster (page 2-40). These
instructions replace the Volume Creation steps
on page 2-21.
Establishing a Redundant Path for the
Microsoft Cluster
4-8 Step 2: Omit
Step 5: Disregard the Note section and use
port 2 (the right port) of each controller.
After completing step 6, follow the instructions
in this section to assign connection paths for
the redundant path of the second cluster
(page 2-41).