Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 2-29
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
Installing Additional Storage Subsystems
The following sections provide information on installing an additional storage
subsystem to the cluster.
Setting Up a Single Cluster with an Additional Storage Subsystem
(Single Controller Configuration)
1. Set up the cluster with the first storage subsystem according to the instructions
starting on page 2-4.
2. To add a second storage subsystem, follow the installation instructions starting
on page 2-4 with the important exceptions included in Table 2-5.
Table 2-5: Setting Up a Single Cluster with an Additional Storage
Subsystem (Single Controller Configuration)
Chapter 2 Section Heading Page Action
Setting Up the Servers 2-3 Omit
Installing the Host Bus
Adapter
2-5 Omit
Installing the StorageWorks
Command Console Client
2-8 Omit
Installing the Adapter Driver 2-11 Omit
Running the FC-AL Setup
Utility
2-12 Omit
Cluster Installation and
Verification
2-22 Omit this and all
following sections.
NOTE: Refer to Chapter 5 for information on adding shared storage.