Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 2-13
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
7. Set the host adapter physical address. The Fibre Channel AL Setup Utility will
set up the required NT registry parameters and prompt you to select an ALPA for
each of your host bus adapters. Use 01 for Host A and 02 for Host B for the host
bus adapters.
8. Restart the system.
9. Repeat steps 1 through 8 on the other server.
Verifying Controller Properties
Perform the following procedures to verify controller properties.
Displaying SCSI Disks in the Devices Windowpane
To display SCSI disks in the devices windowpane:
1. Click Start on the taskbar.
2. Select Programs, Command Console, CLI Window.
3. Select Serial and click OK.
4. Select a baud rate of 9600, and click Connect.
NOTE: If a pop-up window reading “Error scanning subsystem” displays, wait
two minutes and retry the connection.
SWCC finds installed disks and displays them in a grid.
Verifying Properties
To verify the controller properties:
1. Double-click on a controller icon in the Storage Window to display Controller
Properties.