Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Hubs
2-10 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: c-ch2
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:48 PM
8. After the prompt returns, type the following and press Enter:
show this_controller
9. Verify that the “Command Console LUN disabled” text appears in the controller
properties. If so, then continue with the next section.
Setting Port Topologies and the Arbitrated Loop Physical Address
Depending on the configuration, you may need to change the port topology and the
Arbitrated Loop Physical Address (ALPA) settings. To set port topology and ALPA
settings:
NOTE: Refer to the HSG80 documentation for detailed instructions on changing the port
topology and ALPA settings.
1. From the CLI window, type the following and press Enter:
set this_controller port_1_al_pa=71
2. Type the following and press Enter:
set this_controller port_1_topology=loop_hard
3. Type the following and press Enter:
set this_controller port_2_topology=offline
4. Restart the controller by typing the following and pressing Enter:
restart this_controller
5. Wait two minutes for the controller to restart.
6. Type the following and press Enter:
show this_controller
7. Verify the following:
— port_1_topology = loop hard (Loop Up)
— port_1_al_pa = 71 (71 Negotiated)
— port_2_topology = OFFLINE (Offline)