Compaq ProLiant Cluster HA/F500 Administrator Guide

Secure Path Installation Procedures
ProLiant Cluster HA/F500 for MA8000 Administrator Guide 4-21
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: e-ch4
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:52 PM
2. Follow the cluster installation instructions in Chapters 2 and 4 of this guide to set
up the second, third, or fourth storage subsystem, with the important exceptions
included in Table 4-3.
Table 4-3: Setting Up a Single Cluster with an Additional Storage
Subsystem (Dual Controller Configuration, Multibus Failover)
with Hubs
Chapters 2 and 4 Section Heading Page Action
Setting Up the Servers 2-3 Omit
Installing the Host Bus Adapter 2-5 Omit
Installing the StorageWorks Command
Console Client
2-8 Omit
Installing the Adapter Driver 2-11 Omit
Cluster Installation and Verification 2-22 Omit
Installing Secure Path Software 4-4 Omit
Hardware Configuration Overview 4-7 Omit
Establishing a Redundant Path for the
Microsoft Cluster
For Hubs Only
4-8 Step 2: Perform on all
storage subsystems
Steps 4: Omit
Step 5: Connect the
top controller to the
first hub. Connect the
bottom controller to
the second hub.
NOTE: Refer to Chapter 5 for information on adding shared storage.