Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Switches
3-36 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: d-ch3
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:50 PM
Server-to-Storage Connection Paths
Server-to-storage connection paths must be defined when using a switch environment
because additional clusters will be able to see all drives on a switch. The connection
path setting helps segregate the logical units among the clusters.
Single Storage Controller Configurations
The following sections provide information on setting up single storage controller
configurations.
Setting Up an Additional Cluster with a Single Storage Subsystem
To set up an additional cluster with a single storage subsystem:
1. Set up the first cluster according to the instructions starting on page 3-5.
2. Follow the cluster installation instructions in this chapter to set up the second,
third, or fourth cluster with the important exceptions included in Table 3-9.
Table 3-9: Setting Up the Second Cluster
(Single Controller Configuration, Single Storage Subsystem)
Chapter 3 Section Heading Page Action
Set Controller to No Failover 3-12 Omit
Disabling the Command Console LUN 3-13 Omit
Setting Port Topology 3-14 Omit
Discovering Devices 3-14 Execute section if additional
drives are added.
continued