Compaq ProLiant Cluster HA/F500 Administrator Guide

Setting Up the ProLiant Cluster HA/F500 with Switches
3-34 ProLiant Cluster HA/F500 for MA8000 Administrator Guide
COMPAQ CONFIDENTIAL
Writer: Woody Jernigan File Name: d-ch3
Codename: Chargers Part Number: 355220-006 Last Saved On: 7/26/02 2:50 PM
Setting Up a Single Cluster with an Additional Storage Subsystem
(Dual Controller Configuration, Transparent Failover)
1. Set up the cluster with the first storage subsystem according to the instructions in
this chapter starting on page 3-5.
2. Follow the cluster installation instructions in this chapter to set up the second,
third, or fourth storage subsystem, with the important exceptions included in
Table 3-7.
Table 3-7: Setting Up a Single Cluster with an Additional Storage
Subsystem (Dual Controllers, Transparent Failover)
Chapter 3 Section Heading Page Action
Setting Up the Servers 3-5 Omit
Updating Swtich Firmware 3-10 Omit
Combining Switch Models in a Cluster
Configuration
3-11 Omit
Installing the StorageWorks Command
Console Client
3-11 Omit
Installing the Adapter Driver 3-14 Omit
Running the Fibre Channel Fabric Setup Utility 3-16 Omit
Cluster Installation and Verification 3-26 Omit
NOTE: Refer to Chapter 5 for information on adding shared storage.