R21xx-HP FlexFabric 11900 Series High Availability Command Reference

65
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] undo vrrp check-ttl enable
vrrp version
Use vrrp version to specify the version of IPv4 VRRP on an interface.
Use undo vrrp version to restore the default.
Syntax
vrrp version version-number
undo vrrp version
Default
VRRPv3 is used.
Views
Interface view
Predefined user roles
network-admin
Parameters
version-number: Specifies a VRRP version. The version number is 2 or 3, where 2 indicates VRRPv2
(described in RFC 3768), and 3 indicates VRRPv3 (described in RFC 5798).
Usage guidelines
The version of VRRP on all routers in an IPv4 VRRP group must be the same.
Examples
# Specify VRRPv2 to run on VLAN-interface 10.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] vrrp version 2
vrrp vrid authentication-mode
Use vrrp vrid authentication-mode to configure the authentication mode and the authentication key for
an IPv4 VRRP group to send and receive VRRP packets.
Use undo vrrp vrid authentication-mode to restore the default.
Syntax
vrrp vrid virtual-router-id authentication-mode { md5 | simple } { cipher | plain } key
undo vrrp vrid virtual-router-id authentication-mode
Default
Authentication is disabled when a VRRP group sends and receives VRRP packets.
Views
Interface view