R21xx-HP FlexFabric 11900 MPLS Configuration Guide

269
Task Command
Display L2VPN forwarding information (in IRF
mode).
display l2vpn forwarding { ac | pw } [ vsi vsi-name ] [ chassis
chassis-number slot slot-number ] [ verbose ]
Display MAC address table information for
one or all VSIs.
display l2vpn mac-address [ vsi vsi-name ] [ dynamic ]
[ count ]
Display L2VPN PW information. display l2vpn pw [ vsi vsi-name ] [ ldp | static ] [ verbose ]
Display PW class information. display l2vpn pw-class [ class-name ]
Display Ethernet service instance information.
display l2vpn service-instance [ interface interface-type
interface-number [ service-instance instance-id ] ] [ verbose ]
Display VSI information. display l2vpn vsi [ name vsi-name ] [ verbose ]
Clear MAC address entries of one or all VSIs. reset l2vpn mac-address [ vsi vsi-name ]
VPLS configuration examples
Static PW configuration example
Network requirements
Configure VPLS on each PE, and establish static PWs between the PEs to interconnect the CEs.
Figure 74 Network diagram
Configuration procedure
This task includes the following primary configurations:
• Configure basic MPLS on each PE: configure LSR ID, enable LDP, run IGP (OSPF in this example) to
establish LSPs.
• Establish static PWs: enable L2VPN, create static PWs, and specify labels.
1. Configure PE 1:
# Configure an LSR ID.
<PE1> system-view