R21xx-HP FlexFabric 11900 MPLS Command Reference

156
Predefined user roles
network-admin
Parameters
mtu: Specifies an MTU value in the range of 300 to 65535.
Usage guidelines
When LDP is used to create a PW, the PEs at the two ends of the PW must have the same MTU configured
for the cross-connect. Otherwise, the PW cannot come up.
The MTU specifies the maximum packet length, including the control word, PW label, and network layer
packet.
Examples
# Configure an MTU of 1400 bytes for the cross-connect ac2pw in the cross-connect group vpn1.
<Sysname> system-view
[Sysname] xconnect-group vpn1
[Sysname-xcg-vpn1] connection ac2pw
[Sysname-xcg-vpn1-ac2pw] mtu 1400
Related commands
display l2vpn xconnect-group
peer
Use peer to configure a PW for a cross-connect and enter PW view. If the specified PW has been created,
the command places you into PW view.
Use undo peer to delete a PW.
Syntax
peer ip-address pw-id pw-id [ in-label label-value out-label label-value ] [ pw-class class-name |
tunnel-policy tunnel-policy-name ] *
undo peer ip-address pw-id pw-id
Default
No PW is configured for a cross-connect.
Views
Cross-connect view
Predefined user roles
network-admin
Parameters
ip-address: Specifies the LSR ID of the peer PE.
pw-id pw-id: Specifies a PW ID for the PW, in the range of 1 to 4294967295.
in-label label-value: Specifies the incoming label of the PW, in the range of 16 to 1023.
out-label label-value: Specifies the outgoing label of the PW, in the range of 16 to 1023.
pw-class class-name: Specifies a PW class by its name, a case-sensitive string of 1 to 19 characters. If no
PW class is specified, the PW type is determined by the interface type.