R21xx-HP FlexFabric 11900 Layer 3 IP Services Configuration Guide

145
Task Command
Display ICMPv6 traffic statistics (in IRF
mode).
display ipv6 icmp statistics [ chassis chassis-number slot
slot-number ]
Display IPv6 TCP traffic statistics (in
standalone mode).
display tcp statistics [ slot slot-number ]
Display IPv6 TCP traffic statistics (in IRF
mode).
display tcp statistics [ chassis chassis-number slot slot-number ]
Display IPv6 UDP traffic statistics (in
standalone mode).
display udp statistics [ slot slot-number ]
Display IPv6 UDP traffic statistics (in IRF
mode).
display udp statistics [ chassis chassis-number slot slot-number ]
Clear IPv6 neighbor information (in
standalone mode).
reset ipv6 neighbors { all | dynamic | interface interface-type
interface-number | slot slot-number | static }
Clear IPv6 neighbor information (in IRF
mode).
reset ipv6 neighbors { all | dynamic | interface interface-type
interface-number | chassis chassis-number slot slot-number |
static }
Clear IPv6 and ICMPv6 packet statistics
(in standalone mode).
reset ipv6 statistics [ slot slot-number ]
Clear IPv6 and ICMPv6 packet statistics
(in IRF mode).
reset ipv6 statistics [ chassis chassis-number slot slot-number ]
Clear IPv6 TCP traffic statistics. reset tcp statistics
Clear IPv6 UDP traffic statistics. reset udp statistics
IPv6 basics configuration example
Network requirements
As shown in Figure 57, a host, Switch A, and Switch B are connected through Ethernet ports. Add the
Ethernet ports into corresponding VLANs, configure IPv6 addresses for the VLAN interfaces and verify
that they are connected. Switch B can reach the host.
Enable IPv6 on the host to automatically obtain an IPv6 address through IPv6 ND.
Figure 57 Network diagram
Configuration procedure
This example assumes that the VLAN interfaces have been created on the switches.
• Configure Switch A: