R21xx-HP FlexFabric 11900 Fundamentals Configuration Guide

65
2.
Configure the FTP server:
# Examine the storage space on the member devices for insufficiency. If no sufficient free space is
available, use the delete/unreserved file-url command to delete unused files. (Details not shown.)
# Create a local user account abc, set the password to 123456, the user role to network-admin,
the working directory to the Flash root directory of the IRF fabric's active MPU, and the service type
to FTP. (To set the working directory to the Flash root directory of one of the IRF fabric's standby
MPU, replace flash:/ in the authorization-attribute command with, for example,
chassis2#slot1#flash:/.)
<Sysname> system-view
[Sysname] local-user abc class manage
[Sysname-luser-abc] password simple 123456
[Sysname-luser-abc] authorization-attribute user-role network-admin work-directory
flash:/
[Sysname-luser-abc] service-type ftp
[Sysname-luser-abc] quit
# Enable the FTP server.
[Sysname] ftp server enable
[Sysname] quit
3. Perform FTP operations from the FTP client:
# Log in to the FTP server at 1.1.1.1 using the username abc and password 123456.
c:\> ftp 1.1.1.1
Connected to 1.1.1.1 (1.1.1.1).
220 FTP service ready.
User(1.1.1.1:(none)):abc
331 Password required for abc.
Password:
230 User logged in.
# Use the ASCII mode to download the configuration file config.cfg from the server to the client for
backup.
ftp> ascii
200 TYPE is now ASCII
ftp> get config.cfg back-config.cfg
# Use the binary mode to upload the file temp.bin to the Flash root directory of the active MPU of
the IRF fabric.
ftp> binary
200 TYPE is now 8-bit binary
ftp> put temp.bin
# Exit FTP.
ftp> bye
Using the device as an FTP client
Perform the configuration in this section to use the device as an FTP client.
Establishing an FTP connection
To access the FTP server, you must establish a connection from the FTP client to the FTP server.