R211x-HP Flexfabric 11900 TRILL Command Reference

36
Configuration in Layer 2 Ethernet interface view takes effect on only the current port. Configuration in
Layer 2 aggregate interface view takes effect on the current interface and its member ports.
Configuration on the member port of an aggregate interface takes effect after the member port leaves the
aggregation group.
Examples
# Configure VLAN 2 as a designated VLAN.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] trill designated-vlan 2
Related commands
trill announcing-vlan
trill drb-priority
Use trill drb-priority to set the DRB priority of a TRILL port.
Use undo trill drb-priority to restore the default.
Syntax
trill drb-priority priority
undo trill drb-priority
Default
The DRB priority of a TRILL port is 64.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
priority: Specifies the DRB priority for a TRILL port. The priority value is in the range of 0 to 127. A higher
priority value indicates a higher priority.
Usage guidelines
On a broadcast network, TRILL must elect a DRB. An RB with a higher DRB priority is preferred. When two
RBs have the same DRB priority, the RB with a higher MAC address takes precedence.
Configuration in Layer 2 Ethernet interface view takes effect on only the current port. Configuration in
Layer 2 aggregate interface view takes effect on the current interface and its member ports.
Configuration on the member port of an aggregate interface takes effect after the member port leaves the
aggregation group.
Examples
# Set the DRB priority of TRILL port Ten-GigabitEthernet 1/0/1 to 2.
<Sysname> system-view
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] trill drb-priority 2