R211x-HP Flexfabric 11900 TRILL Command Reference

27
lsp-size-exceeded: Specifies notifications about oversized LSPs that result in flooding failures.
max-seq-exceeded: Specifies notifications about LSPs with exceeded serial numbers.
maxarea-mismatch: Specifies notifications about mismatches in maximum area address values.
new-drb: Specifies notifications sent about becoming new DRBs.
own-lsp-purge: Specifies notifications about attempts to purge local LSPs.
protocol-support: Specifies notifications about supported protocol mismatches.
rejected-adjacency: Specifies notifications about mismatched Hello adjacencies that have been rejected.
skip-sequence-number: Specifies notifications about system ID duplications.
topology-change: Specifies notifications sent when the AVF state changes.
version-skew: Specifies notifications about mismatches in Hello packet protocol versions.
Usage guidelines
After you enable SNMP notification sending for TRILL, TRILL will generate notifications to notify the NMS
of important events on the local module and send the notifications to the SNMP module. You can set the
notification sending parameters in SNMP. For more information about notifications, see Network
Management and Monitoring Configuration Guide.
Examples
# Disable SNMP notification sending for TRILL.
<Sysname> system-view
[Sysname] undo snmp-agent trap enable trill
switch-mode port-extender
Use switch-mode port-extender to configure an LSU1TGS48SF0 card to operate in port-extender mode.
Use undo switch-mode to restore the default.
Syntax
In standalone mode:
switch-mode port-extender slot slot-number
undo switch-mode slot slot-number
In IRF mode:
switch-mode port-extender chassis chassis-number slot slot-number
undo switch-mode chassis chassis-number slot slot-number
Default
An LSU1TGS48SF0 card operates in normal mode.
Views
System view
Predefined user roles
network-admin
network-operator