R211x-HP Flexfabric 11900 MPLS Command Reference

320
Use undo vpn-instance-capability to restore the default.
Syntax
vpn-instance-capability simple
undo vpn-instance-capability
Default
OSPF routing loop detection is enabled for a VPN instance.
Views
OSPF view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
In an MCE network, you must disable OSPF routing loop detection for a VPN instance on the MCE.
Otherwise, the MCE does not receive OSPF routes from the PE.
This command is applicable only to OSPF view for a VPN instance.
Examples
# Disable OSPF routing loop detection for VPN instance vpna.
<Sysname> system-view
[Sysname] ospf 100 vpn-instance vpna
[Sysname-ospf-100] vpn-instance-capability simple
vpn-target (VPN instance view/IPv4 VPN view/IPv6 VPN view)
Use vpn-target to configure route targets for a VPN instance.
Use undo vpn-target to remove the specified or all route targets of a VPN instance.
Syntax
vpn-target vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ]
undo vpn-target { all | vpn-target&<1-8> [ both | export-extcommunity | import-extcommunity ] }
Default
No route targets are configured for a VPN instance.
Views
VPN instance view, IPv4 VPN view, IPv6 VPN view
Predefined user roles
network-admin
mdc-admin
Parameters
vpn-target&<1-8>: Specifies route targets. &<1-8> means that you can specify up to eight route targets.
A route target is a string of 3 to 21 characters in one of these formats: