R211x-HP Flexfabric 11900 MPLS Command Reference

294
mdc-admin
Parameters
wtr wtr-time: Specifies the wait time in the range of 0 to 180 seconds. When the primary PW recovers,
the PE waits for the specified time before switching traffic from the backup PW to the primary PW.
never: Disables backup to primary switchover.
Examples
# Specify the switchover wait time as 120 seconds for static PWs in the VSI vpn1.
<Sysname> system-view
[Sysname] vsi vpn1
[Sysname-vsi-vpn1] pwsignaling static
[Sysname-vsi-vpn1-static] revertive wtr 120
Related commands
display l2vpn pw
route-distinguisher
Use route-distinguisher to configure a route distinguisher (RD) for an auto-discovery VSI.
Use undo route-distinguisher to remove the RD.
Syntax
route-distinguisher route-distinguisher
undo route-distinguisher
Default
No RD is configured for an auto-discovery VSI.
Views
Auto-discovery VSI view
Predefined user roles
network-admin
mdc-admin
Parameters
route-distinguisher: Specifies an RD, a string of 3 to 21 characters. An RD can be in one of these formats:
• 16-bit AS number:32-bit user-defined number, such as 101:3.
• 32-bit IP address:16-bit user-defined number, such as 192.168.122.15:1.
• 32-bit AS number:16-bit user-defined number, such as 65536:1. In this format, the minimum value of
the AS number is 65536.
Usage guidelines
MPLS L2VPN uses RDs to differentiate the sites that reside in different VPNs and have the same site ID.
BGP adds the configured RD before the site ID. The RD and the site ID uniquely identify a VPN site.
The configure RD applies to both BGP neighbor auto-discovery and label block advertisement.
You cannot configure the same RD for different BGP VSIs.