R211x-HP Flexfabric 11900 MPLS Command Reference

99
Sender address: 2.2.2.9 LSP ID: 17767
Setup priority: 7 Holding priority: 7
FRR desired: Disabled Upstream label: 1115
Previous hop: 57.10.10.1 Previous hop LIH: 0xf0008
Average bitrate: 125.00 kbps Maximum burst: 0.00 bytes
MTU: 1500 Qos service: Controlled-Load
Recv message epoch: 0 Recv message ID: 0
Send message epoch: 0 Send message ID: 0
In-Interface: Vlan15 Local LIH: 0x67
Local address: 10.11.112.140 Refresh interval: 30000 ms
Out-Interface: Vlan16 Nexthop: 10.11.112.135
Unknown object number: 0
Receive ERO number: 5
2.2.2.9/32 Strict
10.11.112.140/32 Strict
10.11.112.135/32 Strict
57.40.40.3/32 Strict
57.40.40.1/32 Strict
Send ERO number: 3
10.11.112.135/32 Strict
57.40.40.3/32 Strict
57.40.40.1/32 Strict
RRO number: 0
Fast Reroute PLR: None
Fast Reroute MP: None
Table 38 Command output
Field Descri
p
tion
Destination Tunnel destination address.
Source LSR ID of the device at the tunnel source end.
Style
Resource reservation style:
• SE—Shared-explicit style.
• FF—Fixed-filter style.
Sender address Sender address identifies the tunnel source end.
FRR desired State of FRR: enabled or disabled.
Upstream label Incoming label of the forward LSP.
Previous hop LIH Logical interface handle of the previous hop.
QoS service QoS service type: Controlled-Load or Guaranteed.
Recv message Epoch Value of the Epoch field in the Message ID object of the received message.
Recv message ID Message ID in the received message.
Send message epoch Value of the Epoch field in the Message ID object of the sent message.
Send message ID Message ID in the sent message.
In-Interface Incoming interface of the message.
Local LIH Local logical interface handle.