R211x-HP Flexfabric 11900 MPLS Command Reference

96
Field Descri
p
tion
Style
Resource reservation style:
• SE—Shared-explicit style.
• FF—Fixed-filter style.
# Display detailed information about all RSVP resource reservation states.
<Sysname> display rsvp reservation verbose
Destination: 3.3.3.9 Source: 1.1.1.9
Tunnel ID: 1 Style: SE
Nexthop: 57.20.20.1 Nexthop LIH: 0x35
Recv message epoch: 0 Recv message ID: 0
In-Interface: Vlan10 Unknown object number: 0
Flow descriptor 1:
Flow specification:
Average bitrate: 50.00 kbps Maximum burst: 1000.00 bytes
Path MTU: 1500 QoS service: Controlled-Load
Filter specification 1:
Sender address: 1.1.1.9 LSP ID: 23
Label: 3
RRO number: 3
57.20.20.1/32 Flag: 0x40 (No FRR/In-Int)
3 Flag: 0x01 (Global label)
3.3.3.9/32 Flag: 0x20 (No FRR/Node-ID)
Table 36 Command output
Field Descri
p
tion
Destination Tunnel destination address.
Source Tunnel source address.
Style
Resource reservation style:
• SE—Shared-explicit style.
• FF—Fixed-filter style.
Nexthop LIH Logical interface handle of the local outgoing interface for the next hop.
Recv message epoch Value of the Epoch field in the Message ID object of the received message.
Recv message ID Message ID in the received message.
In-Interface Incoming interface of the message.
Unknown object number Number of unknown objects.
QoS service QoS service type: Controlled-Load or Guaranteed.
Sender address Sender address identifies the tunnel source end.
Label Outgoing label of the forward LSP.
RRO number
Number of RROs.
If the number is not 0, the subsequent output displays the IP addresses or
labels recorded in the RROs.
The RRO information is displayed only when route recording is configured
on the tunnel interface.