R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

276
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
vlan vlan-id: Specifies the VLAN where the DHCPv6 clients resides.
remote-id: Specifies the a string of 1 to 128 characters as the remote ID.
Examples
# Specify device001 as the remote ID.
<Sysname> system-view
[Sysname] ipv6 dhcp snooping enable
[Sysname] interface Ten-GigabitEthernet1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] ipv6 dhcp snooping option remote-id enable
[Sysname-Ten-GigabitEthernet1/0/1] ipv6 dhcp snooping option remote-id string device001
Related commands
• ipv6 dhcp snooping enable
• ipv6 dhcp snooping option remote-id enable
ipv6 dhcp snooping rate-limit
Use ipv6 dhcp snooping rate-limit to specify the maximum rate at which an interface can receive
DHCPv6 packets.
Use undo ipv6 dhcp snooping rate-limit to remove the rate limit.
Syntax
ipv6 dhcp snooping rate-limit rate
undo ipv6 dhcp snooping rate-limit
Default
Incoming DHCPv6 packets on an interface are not rate limited.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
rate: Specifies the maximum rate for an interface to receive DHCPv6 packets, in Kbps. The value range
depends on the device model.
Usage guidelines
This command takes effect only when DHCPv6 snooping is enabled.