R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

260
DHCPv6 relay agent commands
The term "interface" in this section collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.
You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see
Layer 2—LAN Switching Configuration Guide).
display ipv6 dhcp relay server-address
Use display ipv6 dhcp relay server-address to display DHCPv6 server addresses specified on the
DHCPv6 relay agent.
Syntax
display ipv6 dhcp relay server-address [ interface interface-type interface-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number. If you do not
specify an interface, the command displays DHCPv6 server addresses on all interfaces enabled with
DHCPv6 relay agent.
Examples
# Display DHCPv6 server addresses on all interfaces enabled with DHCPv6 relay agent.
<Sysname> display ipv6 dhcp relay server-address
Interface: Vlan-interface2
Server address Outgoing Interface
2::3
3::4 Vlan-interface4
Interface: Vlan-interface3
Server address Outgoing Interface
2::3
3::4 Vlan-interface4
# Display DHCPv6 server addresses on VLAN-interface 2.
<Sysname> display ipv6 dhcp relay server-address interface vlan-interface 2
Interface: Vlan-interface2
Server address Outgoing Interface
2::3
3::4 Vlan-interface4