R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

232
Usage guidelines
When no non-temporary IPv6 address range is specified, all unicast addresses on the subnet specified
by the network command in address pool view are assignable. If a non-temporary IPv6 address range
is specified, only the IPv6 addresses in the IPv6 address range are assignable.
You can specify only one non-temporary IPv6 address range in an address pool. If you use the address
range command multiple times, the most recent configuration takes effect.
The non-temporary IPv6 address range specified by the address range command must be on the subnet
specified by the network command.
Examples
# Configure a non-temporary IPv6 address range from 3ffe:501:ffff:100::10 through 3ffe:501:ffff:100::31
in address pool 1.
<Sysname> system-view
[Sysname] ipv6 dhcp pool 1
[Sysname-dhcp6-pool-1] network 3ffe:501:ffff:100::/64
[Sysname-dhcp6-pool-1] address range 3ffe:501:ffff:100::10 3ffe:501:ffff:100::31
Related commands
• display ipv6 dhcp pool
• network
• temporary address range
display ipv6 dhcp pool
Use display ipv6 dhcp pool to display information about a DHCPv6 address pool.
Syntax
display ipv6 dhcp pool [ pool-name ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
pool-name: Displays information about the specified DHCPv6 address pool. The pool name is a
case-insensitive string of 1 to 63 characters. If no pool name is specified, the command displays
information about all DHCPv6 address pools.
Examples
# Display information about DHCPv6 address pool 1.
<Sysname> display ipv6 dhcp pool 1
DHCPv6 pool: 1
Network: 3FFE:501:FFFF:100::/64