R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

173
IPv6 basics commands
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN interfaces
and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port
link-mode route command (see Layer 2—LAN Switching Configuration Guide).
display ipv6 fib
Use display ipv6 fib to display IPv6 FIB entries.
Syntax
display ipv6 fib [ vpn-instance vpn-instance-name ] [ ipv6-address [ prefix-length ] ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters.
ipv6-address: Specifies an IPv6 address.
prefix-length: Specifies a prefix length for the IPv6 address, in the range of 0 to 128.
Usage guidelines
If you do not specify a VPN, this command displays IPv6 FIB entries for the public network.
If you do not specify the prefix length, this command displays the IPv6 FIB entry longest matching the IPv6
address. If you specify a prefix, this command displays the IPv6 FIB entry that exactly matches the IPv6
address and prefix length.
If you do not specify any parameter, this command displays all IPv6 FIB entries for the public network.
Examples
# Display all IPv6 FIB entries for the public network.
<Sysname> display ipv6 fib
Destination count: 1 FIB entry count: 1
Flag:
U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:Static
R:Relay F:FRR