R211x-HP Flexfabric 11900 Layer 3 - IP Services Command Reference

139
IP performance optimization commands
The term "interface" in this chapter collectively refers to Layer 3 interfaces, including VLAN interfaces
and Layer 3 Ethernet interfaces. You can set an Ethernet port as a Layer 3 interface by using the port
link-mode route command (see Layer 2—LAN Switching Configuration Guide).
display icmp statistics
Use display icmp statistics to display ICMP statistics.
Syntax
In standalone mode:
display icmp statistics [ slot slot-number ]
In IRF mode:
display icmp statistics [ chassis chassis-number slot slot-number ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
slot slot-number: Displays ICMP statistics for the specified card. The slot-number argument specifies the
slot number of the card. (In standalone mode.)
chassis chassis-number slot slot-number: Displays ICMP statistics for the specified card on the specified
IRF member device. The chassis-number argument specifies the ID of the IRF member device. The
slot-number argument specifies the slot number of the card. (In IRF mode.)
Usage guidelines
ICMP statistics include information about received and sent ICMP packets.
Examples
# Display ICMP statistics.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 175 destination unreachable 0
source quench 0 redirects 0
echo replies 201 parameter problem 0
timestamp 0 information requests 0
mask requests 0 mask replies 0
time exceeded 0 invalid type 0