R211x-HP Flexfabric 11900 IP Multicast Command Reference

221
• state-refresh-interval (IPv6 PIM view)
• state-refresh-rate-limit (IPv6 PIM view)
state-refresh-interval (IPv6 PIM view)
Use state-refresh-interval to set the interval for sending state refresh messages.
Use undo state-refresh-interval to restore the default.
Syntax
state-refresh-interval interval
undo state-refresh-interval
Default
The state refresh interval is 60 seconds.
Views
IPv6 PIM view
Predefined user roles
network-admin
mdc-admin
Parameters
interval: Specifies the interval for sending state refresh messages, in the range of 1 to 255 seconds.
Examples
# Set the interval for sending state refresh messages to 70 seconds on the public network.
<Sysname> system-view
[Sysname] ipv6 pim
[Sysname-pim6] state-refresh-interval 70
Related commands
• ipv6 pim state-refresh-capable
• state-refresh-hoplimit (IPv6 PIM view)
• state-refresh-rate-limit (IPv6 PIM view)
state-refresh-rate-limit (IPv6 PIM view)
Use state-refresh-rate-limit to configure the time that the device waits before receiving a new state refresh
message.
Use undo state-refresh-rate-limit to restore the default.
Syntax
state-refresh-rate-limit time
undo state-refresh-rate-limit
Default
The device waits 30 seconds before it receives a new state refresh message.