R211x-HP Flexfabric 11900 Fundamentals Configuration Guide

29
Ste
p
Command Remarks
4. Enable password
authentication.
authentication-mode password
By default, password authentication is
enabled for VTY lines.
In VTY line view, this command is
associated with the protocol inbound
command:
• If the setting of either command is
not the default in VTY line view, the
setting of the other command in VTY
line view takes effect.
• If the settings of both commands are
the defaults in VTY line view, the
settings of the commands in VTY line
class view take effect.
5. Set a password.
set authentication password { hash |
simple } password
By default, no password is set.
6. (Optional.) Assign a
user role.
user-role role-name
By default, a VTY line user of the default
MDC is assigned the user role
network-operator, and a VTY line user
of a non-default MDC is assigned the
user role mdc-operator.
The next time you attempt to Telnet to the device, you must provide the configured login password, as
shown in Figure 10. If th
e maximum number of login users has been reached, your login attempt fails and
the message "All user lines are used, please try later!" appears.
Figure 10 Password authentication interface for Telnet login
Configuring scheme authentication for Telnet login
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable Telnet server.
telnet server enable
By default, the Telnet server function is
disabled.