R211x-HP Flexfabric 11900 Fundamentals Configuration Guide
191
# Reclaim the interface card in slot 6 from the default MDC and assign it to MDCC.
[Device-mdc-4-MDCC] mdc Admin
[Device-mdc-1-Admin] undo location slot 6
The configuration associated with the specified slot of MDC will be lost. Continue?
[Y/N]:y
[Device-mdc-4-Admin] mdc MDCC
[Device-mdc-4-MDCC] location slot 6
# Assign interfaces Ten-GigabitEthernet 6/0/1 through Ten-GigabitEthernet 6/0/48 to MDCC.
[Device-mdc-4-MDCC] allocate interface ten-gigabitethernet 6/0/1 to
ten-gigabitethernet 6/0/48
The configurations of the interfaces will be lost. Continue? [Y/N]:y
# Set the CPU weight of MDCC to 5.
[Device-mdc-4-MDCC] limit-resource cpu weight 5
# Start MDCC.
[Device-mdc-4-MDCC] mdc start
It will take some time to start MDC...
This MDC was started successfully.
[Device-mdc-4-MDCC] quit
# Log in to MDCC from the default MDC. Press Ctrl+D as prompted to access the CLI of MDCC.
[Device] switchto mdc MDCC
******************************************************************************
* Copyright (c) 2010-2013 Hewlett-Packard Development Company, L.P. *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
Automatic configuration is running, press CTRL_D to break or press CTRL_B to
switch back to the default MDC.
<Device> system-view
# Change the device name to MDCC for easy identification of the MDC.
[Device] sysname MDCC
# To enable the MDC administrator to remotely manage the MDC, assign an IP address to the
management Ethernet interface and enable the Telnet service.
[MDCC] interface M-GigabitEthernet 0/0/0
[MDCC-M-GigabitEthernet0/0/0]ip address 192.168.3.253 24
[MDCC-M-GigabitEthernet0/0/0] quit
[MDCC] telnet server enable
[MDCC] user-interface vty 0 63
[MDCC-line-vty0-63] authentication-mode none
[MDCC-line-vty0-63] user-role mdc-admin
# Return to the default MDC.
[MDCC-line-vty0-63] return
<MDCC> switchback
[Device]
Verifying the configuration
1. Verify that the MDCs exist and are operating correctly.