R211x-HP Flexfabric 11900 EVB Configuration Guide

4
Do not enable both EVB and VLAN mapping, or both EVB and TRILL on the same interface.
Do not execute the qinq enable or qinq ethernet-type command on an interface enabled with EVB, and
vice versa. For more information about the two commands, see Layer 2—LAN Switching Command
Reference.
To enable EVB:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
3. Enable EVB.
evb enable
By default, EVB is disabled on an
interface.
Configuring LLDP
EVB uses LLDP to transmit CDCP TLVs, and CDCP TLVs are carried by the LLDP packet that is addressed
using the Nearest non-TPMR Bridge address, so you must configure LLDP.
For detailed information about the lldp global enable, lldp enable and lldp agent nearest-nontpmr
admin-status commands, see Layer 2—LAN Switching Command Reference.
To configure LLDP:
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Enable LLDP globally.
lldp global enable
By default, LLDP is disabled
globally.
3. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
interface interface-type
interface-number
N/A
4. Enable LLDP on the interface
lldp enable
By default, LLDP is enabled on an
interface.
5. Configure the Nearest
non-TPMR Bridge agent for
LLDP to operate in TxRx mode.
lldp agent nearest-nontpmr
admin-status txrx
The default mode is disable.
Specifying a default VSI manager
When the bridge receives a VDP packet other than a De-Associate packet from a station, it contacts the
VSI manager specified in the VDP packet to get VSI resources and policies for the station.
The VSI manager ID TLV in a VDP packet carries the VSI manager's IP address. If the value for the TLV is
0, the VDP packet does not contain a VSI manager's IP address, so the bridge communicates with the
specified default VSI manager.
To specify a default VSI manager: