R211x-HP Flexfabric 11900 EVB Configuration Guide
10
• When a filter configured on a VSI aggregate interface contains information about a VLAN, you
must not configure the filter on the same VSI aggregate interface again or on other VSI aggregate
interfaces of the S-channel aggregate interface. If you do, an error message appears.
• Activate a VSI aggregate interface after configuring a VSI filter, and deactivate a VSI aggregate
interface before removing a VSI filter.
To configure a VSI filter:
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VSI view or VSI
aggregate interface view.
interface { s-channel |
schannel-aggregation }
interface-number:channel-id.vsi-loc
al-id
N/A
3. Configure a VSI filter.
evb vsi filter [ group group-id ] vlan
vlan-id [ mac mac-address ]
By default, no VSI filter is
configured.
Activating a VSI or VSI aggregate interface
Configurations such as traffic monitoring (see ACL and QoS Configuration Guide) on a VSI or VSI
aggregate interface take effect only after the VSI or VSI aggregate interface is activated. When a VSI or
VSI aggregate interface is not activated, only configure filters on the VSI or VSI aggregate interface.
Activate a VSI or VSI aggregate interface after configuring a VSI filter, and deactivate a VSI or VSI
aggregate interface before removing a VSI filter.
To activate a VSI:
Ste
p
Command
Remarks
1. Enter system view.
system-view
N/A
2. Enter VSI view.
interface s-channel
interface-number:channel-id.vsi-lo
cal-id
N/A
3. (Optional.) Configure
the expected bandwidth
of the VSI.
bandwidth bandwidth-value
By default, the expected bandwidth of a
VSI is the default maximum bandwidth of
the physical port to which the VSI
belongs.
4. (Optional.) Restore the
default settings for the
VSI.
default N/A
5. (Optional.) Configure a
description for the VSI.
description text
The default description information is
"interface name Interface."
6. Activate the VSI.
evb vsi active By default, no VSI is activated.
To activate a VSI aggregate interface:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A