R211x-HP Flexfabric 11900 EVB Configuration Guide

ManualsBrandsHP ManualsNetwork HardwareHP FlexFabric 11000 Switch Products

Configuring MAC address learning for an S-channel

You can manually disable the MAC address learning function for an S-channel by performing this task.

To disable MAC address learning for an S-channel:

Ste

Command

Remarks

1. Enter system view.

system-view

N/A

2. Enter S-channel interface

view or S-channel aggregate

interface view.

interface { s-channel |

schannel-aggregation }

interface-number:channel-id

N/A

3. Disable MAC address

learning for the S-channel.

evb mac-learning forbidden

By default, the MAC address

learning function is enabled for an

S-channel.

IMPORTANT:

• For an S-channel with the RR

mode disabled, do not disable

its MAC address learning

function. Otherwise, the

bridge might fail to forward

traffic for VMs on the EVB

station.

• After you disable the MAC

address learning function for

an S-channel, the bridge will

discard packets with an

unknown source MAC

address.

Configuring a VSI or VSI aggregate interface

Creating a VSI or VSI aggregate interface

A VSI is created on an S-channel interface through this task, and it is a subinterface of the S-channel

interface. A VSI aggregate interface is created on an S-channel aggregate interface, and it is a

subinterface of the S-channel aggregate interface. Removing an S-channel also removes all its VSIs and

VSI aggregate interfaces.

VSIs or VSI aggregate interfaces are typically created by a VSI manager. You can create a VSI or VSI

aggregate interface, or modify its Pre-Associate and Associate properties through this task.

To create a VSI or VSI aggregate interface:

Ste