HP Software File Migration Agent Installation and Administration Guide (September 2009)

166 | Error Codes and Messages
0x00060003 Authentication at
storage archive
storage system
failed. Check
supported
credentials
Error: The system can connect
to the remote archive system,
but the designated user did not
have sufficient credentials to
read from or write to it. This
can occur during most
operations that require reading
or writing to the remote
archive.
Check archive settings in the
RSA configuration. Check that
the archive user's credentials
are set correctly locally and in
the remote archive system. For
CIFS archives, the FMA
technical user needs to have
full control privileges in the
remote archive system. Any
change to the RSA
configuration settings after its
initial creation does not take
effect until after the FMA
services are restarted.
0x00060004 File cannot be
stored in archive
system.
Error: The file can not be
written to the archive system
during migration because it is
out of storage space.
Check archive for capacity
availability.
0x00060005 Configuration
dialog cancelled
Warning: The RSA
configuration dialog was
cancelled by the user.
None.
0x00060006 Configuration
dialog error
Error: An unexpected error in
RSA configuration occurred.
Try the operation again. Try to
restart the FMA services or
reboot the server. Contact HP
Support if the problem persists.
0x00060008 No message
displayed
Warning: An alternate location
for a given archive was not
defined. This can occur during
recalls if the secondary archive
is omitted and the primary is
not accessible.
This is not an error if the
secondary path to the archive
is left blank on purpose. If not,
check the secondary archive
configuration and if it is
online.
0x00060009 The archive does
not support the
requested function.
Error: There are some
advanced functions that are not
supported by the remote
archive system. These are
typically not invoked by FMA.
This error can occur during
archive management.
If this issue is seen frequently,
contact HP Support.
0x00060010 No message
displayed
Error: A retry of a previous
command was requested.
None.
Error Code Error Text Description Recommended Action