Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

834 Fabric OS Message Reference
53-1002149-01
SULB-1035
139
Recommended
Action
Reboot the switch. This will cause the internal image to be relocated again. Use the
firmwareDownloadStatus command to monitor the progress. If the problem persists, contact your
switch service provider.
Severity ERROR
SULB-1035
Message AUDIT, <timestamp>, [SULB-1035], ERROR, FIRMWARE, <event-initiator-details>,
<event-location>, , An error has occurred during relocation of the internal image.
Probable Cause Indicates an error has occurred during the relocation of the internal image. The error may be
caused by inconsistent internal firmware image. It may also be caused by the internal Ethernet or
persistent storage hardware failure.
Recommended
Action
Reset the switch. This will cause the internal image to be relocated again. If the problem persists,
contact your switch service provider.
Severity ERROR
SULB-1037
Message AUDIT, <timestamp>, [SULB-1037], ERROR, FIRMWARE, HCL failed. Reboot the switch
manually using the reboot command. However, it will disrupt the FC traffic.
Probable Cause Indicates HCL has failed. Many reasons, such as domain not confirmed, can cause this failure.
Recommended
Action
Run the reboot command to reboot the switch manually.
Severity ERROR
SULB-1038
Message AUDIT, <timestamp>, [SULB-1038], WARNING, FIRMWARE, Co-CPU has not booted up
properly. Skip the firmwaredownload command on the co-CPU.
Probable Cause Indicates that the Main CPU cannot access the co-CPU to update the firmware on the co-CPU or run
any other firmwaredownload command on the co-CPU. If firmwareDownload in progress it will
continue without updating the co-CPU firmware.
Recommended
Action
After firmwaredownload completes, reboot the CP manually to bring up the co-CPU and run the
firmwareDownload command again. If the problem persists, contact the service provider.
Severity WARNING