Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 779
53-1002149-01
Chapter
129
AUDIT FW System Messages
FW-1202
Message AUDIT, <timestamp>, [FW-1202], WARNING, FW, <event-initiator-details>,
<event-location>, , <Port Name>, <Label>, is above high boundaries (High=<High
value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of C3 transmit time out frames is above high threshold.
Recommended
Action
Check the target device; it could be slow.
Severity WARNING
FW-1274
Message AUDIT, <timestamp>, [FW-1274], INFO, FW, <event-initiator-details>,
<event-location>, , <Label>, is above high boundary(High=<Filter Counter>,
Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the number of frame types or commands that the port receives has risen above the
high boundary. The port has received a small computer system interface (SCSI) Read, SCSI Write,
SCSI Read and Write, SCSI Traffic, or IP commands in a frame.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1402
Message AUDIT, <timestamp>, [FW-1402], WARNING, FW, <event-initiator-details>,
<event-location>, , <Label>, is above high boundary(High=<High value>, Low=<Low
value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the flash usage percentage has risen above the high boundary. Flash increases and
decreases slightly with normal operation of the switch. Excessive permanent increases can lead to
future problems.
Recommended
Action
You might have to remove some unwanted files to create some flash space. Run the supportSave
command to remove files from the kernel space.
Severity WARNING