Fabric OS Message Reference v7.0.0 (53-1002149-01, April 2011)

Fabric OS Message Reference 35
53-1002149-01
AG-1038
2
Recommended
Action
If the switchshow command on the connected fabric switch port displays 'Persistently disabled:
Area has been acquired', then check the cabling on the AG. All trunked ports in a single trunk
should belong to the same ASIC Port Group.
Severity INFO
AG-1038
Message <timestamp>, [AG-1038], <sequence-number>,, ERROR, <system-name>,Elara Ports
going to different fabrics, Check N Port <nport>.
Probable Cause Indicates a misconfiguration.
Recommended
Action
Connect all ports in the port group to the same fabric.
Severity ERROR
AG-1039
Message <timestamp>, [AG-1039], <sequence-number>,, INFO, <system-name>,F-Port <Port that
was reset> was reset because a WWN mapped device using it, through N-Port <Port
who's state change caused the reset>, went offline.
Probable Cause Indicates a port needed to be reset because an N-Port went offline and the changes need to be
propagated to all involved devices.
Recommended
Action
No action is required. This port reset was not an error.
Severity INFO
AG-1040
Message <timestamp>, [AG-1040], <sequence-number>,, WARNING, <system-name>, PID of the
devices connected to Port <port> may have changed, as the port was toggled. Check
EE monitor’s configuration as it might not be functional.
Probable Cause Indicates that the NPIV assigns a new PID each time the same port is disabled and then
re-enabled. As the PID has changed, the EE monitors installed with the previous PID stops
functioning.
Recommended
Action
Install new EE monitors with the new PID of the port to be monitored.
Severity WARNING