Event Monitoring Service Version A.03.20.
Legal Notices The information contained in this document is subject to change without notice. Hewlett-Packard makes no warranty of any kind with regard to this manual, including, but not limited to, the implied warranties of merchantability and fitness for a particular purpose. Hewlett-Packard shall not be liable for errors contained herein or direct, indirect, special, incidental or consequential damages in connection with the furnishing, performance, or use of this material.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i 1 Event Monitoring Service Version A.03.20.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Announcements Announcements Version A.03.20.01 of the Event Monitoring Service (B7609BA), includes media, license and manual. Version A.03.20.01 runs on HP-UX 11i B.11.11. It is available for HP 9000/Series 700 and 800. Use the Event Monitoring Service (EMS), together with one or more EMS monitors, to monitor various system resources. The EMS product includes the framework and general monitors.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Announcements • The MIB Monitors: — HA Cluster Monitor checks the status of ServiceGuard clusters, nodes, or packages and services. — HA Network Interface Monitor reports the status of LAN interfaces. — HA System Resource Monitor checks the number of users, tge system load, and the amount of file system space.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i What’s New in this Version What’s New in this Version The A.03.20.01 Version of Event Monitoring Service is a minor release, for HP-UX 11i. It runs only on HP-UX, Version 11i B.11.11 or later. The Draft version of Event Monitoring Service supports the same configurations as versions A.03.00 through A.03.20. What Manuals are Available for This Version The following manuals are shipped with the Event Monitoring Service A.03.20.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Compatibility Information and Installation Requirements Compatibility Information and Installation Requirements EMS should be installed on each node that you want to monitor. It does not need to be installed on the management station, unless you want to also monitor the management station itself.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Compatibility Information and Installation Requirements Table 1-2 EMS MC/ServiceGuard Compatibility EMS Version HP-UX Release ServiceGuard Version A.02.00 HP-UX 11.00 MC/ServiceGuard A.11.01, A.11.03 HP-UX 11.00 MC/LockManager A.11.01, A.11.02, A.11.03 HP-UX 10.20 MC/ServiceGuard A.10.11, A.10.12 HP-UX 11.00 MC/ServiceGuard A.11.04, A.11.05, A.11.07, A.11.08, A.11.09 A.03.00, A.03.00.01, A.03.10, and A.03.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Compatibility Information and Installation Requirements Hardware Requirements EMS runs on the HP 9000 series 700 and 800 servers. Disk Requirements EMS requires 2.75 Mb of disk space to install. An additional 13.0 Mb of disk space should be allocated for /etc/opt to support EMS logging facilities. Memory Requirements EMS requires approximately 3 Mb of memory to execute.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Compatibility Information and Installation Requirements resources You can install EMS either of these ways: • Use swinstall, or • Use the Software Management area in SAM If you have many systems, it may be easier to install over the network from a central location: 1. Create a network depot according to the instructions in Managing HP-UX Software with SD-UX. 2. rlogin or telnet to the remote host on which you are installing EMS. 3.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Compatibility Information and Installation Requirements CAUTION When you remove EMS, all log files are also removed. If you wish to save any of the EMS log files, rename them or store them off before you remove EMS.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Patches and Fixes in this Version Patches and Fixes in this Version This section describes patches that are required and defects that have been fixed in Version Draft of Event Monitoring Service. Required and Recommended Patches No patches are required for EMS Draft. Fixes and Changes Two defects are fixed in EMS Version A.03.20.01 for 11i.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Known Problems and Workarounds Known Problems and Workarounds The following are known problems and suggested workarounds with the EMS: JAGab77527: EMS client may fail to connect to the registrar What is the problem? An EMS client may fail to connect to the EMS registrar. If this occurs, you may see a message in /etc/opt/resmon/log/client.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Known Problems and Workarounds registrar stream tcp nowait root \ /etc/opt/resmon/lbin/registrar \ /etc/opt/resmon/lbin/registrar Be sure the following line is in the /etc/services file: registrar 1712/tcp # resource monitor service Then enter inetd -c to reconfigure inetd. 2. Retry running the client that failed.
Event Monitoring Service Version A.03.20.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Known Problems and Workarounds /etc/opt/resmon/lbin/registrar After you have confirmed both registrar requirements, reconfigure inetd by executing: inetd -c • Add the /etc/services file to the lookup path your name lookup service uses. For example, modify the nsswitch.conf file to refer to /etc/services if you are running NIS.
Event Monitoring Service Version A.03.20.01 Release Notes for HP-UX 11i Software Availability in Native Languages Software Availability in Native Languages Event Monitoring Service, Version Draft, is available with documentation in American English or Japanese. (The interface is available only in American English.
Event Monitoring Service Version A.03.20.
