HP StorageWorks EVA6400/8400 M6412A disk enclosure installation instructions

Figure 1 Disk enclosure kit contents
Rails with –03 brackets5Disk enclosure1
Two Fibre Channel copper cables6Eight disk drive blanks (may come pre-installed in
enclosure)
2
Two enclosure power cords7–04 brackets (not used)3
Accessory kit4
Attaching the rails
The rail kit supplied with the disk enclosure comes configured for square-hole racks.
IMPORTANT: Do not remove the pins from the ends of the rails unless you are converting the rails
for use in round-hole racks. These load-bearing pins are designed to fit through the holes without being
removed.
If you need to convert the rails for a round-hole rack:
1. Locate the accessory kit bag included in the disk enclosure kit.
2. Use a No. 2 Phillips screwdriver to remove the standard pins from the front and back of the left
and right rack rails. See Figure 2 (page 4).
Figure 2 Removing square-hole pins from rail
3. Attach the round-hole pins (four on each rail) into the eight holes on the rails where the standard
pins were removed.
4 Attaching the rails