HP Enterprise Virtual Array 6400/8400 Expansion Rack Reference Guide (5697-1818, March 2012)

1
Use 1 AP712A per each of the first 3 disk enclosures.
Table 2 EVA8400 0C9D expansion
DescriptionQuantity per 0C9DExpansion rack components
EVA 42U HP 10000 Intelligent Series
rack
1AF002A
Power distribution unit (country specific)2 (minimum HV)
4 (minimum LV)
252663–xxx
M6412–A FC disk enclosure9AG638B
HP EVA6400/8400 expansion rack
accessory kit, which contains:
3AP712A
1
• HP 5m Multi-mode OM3 LC/LC FC
Cable (4)
• 4Gb Short Wave FC SFP+ 1 Pack
(8)
• ROHS, SPOOL, Millennium Cable
(4)
• Velcro, Strap 5" (8)
• Label, Cable Kit (2) - 1 blank
red/green; 1 numbered red/green
1
Use 1 AP712A per each of the first 3 disk enclosures.
0CxD Expansion rack requirements
• One existing 2CxD main rack containing a properly wired controller pair and disk enclosures
(see Figure 1 (page 6)).
The controllers may be above or in the middle of the disk enclosures, depending on the number
of disk enclosures and how the rack was initially configured. Figure 1 (page 6) is an example
only, showing six disk enclosures below the EVA8400 controllers.
• The main rack must be running properly.
• A new 0CxD expansion rack containing properly wired disk enclosures (see Figure 2 (page
7)). Figure 2 (page 7) is an example only, showing six disk enclosures and assuming there
are six disk enclosures in the main rack.
0CxD Expansion rack requirements 5