HP StorageWorks Controller Blower Replacement Instructions (5697-5246, March 2006)

HP StorageWorks
Controller Blower Replacement
Instructions
These instructions apply to the EVA
4000/6000/8000 product family. The part
may also be used in other HP products. Please refer to
documentation for your specific product for detailed
replacement instructions.
Printed on at least 50% total recyc led fiber with at least
10% post-consumer paper.
© Copyright 2005 Hewlett-Packard Development Company, L.P.
Second edi
tion March 2006
Product names mentioned herein may be trademarks of their
respectivecompaniesasreflected by an associated footnote.
The information in this document is subject to change without
notice.
Printed in the U.S.A.
www.hp.com
.
*5697-5246*
Warranty Inform
ation
If the product in
whichthispartisbeingreplacedisstillunder
HP warranty, then the replacement part(s) referred to in these
Replacement Instructions is provided under the terms and conditions
of the Hewlett-Packard Company Limited Warranty for that
product. A copy of this Limited Warranty may be viewed at:
h
ttp://h1 8006.www1.hp.com/products/storageworks/warranty.html
If this is a tra
de sale part (product out of warranty), then the replacement
part(s) refe
rred to in these Replacement Instructions is provided under
HP's express
limited warranty statement, which may be viewed at:
h
ttp://cust
omerops.corp.hp.com/1sw/pdm_om/warranty_support/
policies/2
330100.doc
The replace
ment part takes on either the Limited Warranty Period of the
part being r
eplaced or a ninety-day period that begins upon installation
of the replacement par t, whichever is greater.
The only wa
rrantyforthisreplacementproductisasnotedabove.
Nothing in
these replacement instructions should be construed as
constituting an additional warranty. The information provided in these
replacem
ent instructions is p rovided "AS IS" and HP is not liable for
technic
al or editorial errors or omissions contained herein.
About This Document
This document describes the procedure for replacing the blower used in
Enterprise Virtual Array 4000/6000/8000 products.
Before you begin
Observe the following precautions when replacing a battery.
CAUTION:
Removing a blower significantly changes the air flow within the
enclos
ure. Both blowers must be installed for the enclosure
to cool
properly. If a blowers fails, leave it in place in the
enclos
ure until a new blower is available to install.
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
Have a copy of the product User Guide available for reference.
You can download a copy of the User Guide from the product
support page on the HP web site.
Verif ying component failure
Before replacing a blower , use the following methods to verify the
component failure:
CAUTION:
If Command View EVA does not present a status consistent with
that of the blower status indicators, or if Command Vie w or the
System Event Analyzer indicates multiple hardware failures,
contact HP support for assistance. The HP support web site is
located at h
ttp://www.hp.com/support
Page 1