HP StorageWorks Novell NetWare Connectivity 3.0H for the 3000/5000 Enterprise Virtual Array Release Notes (5697-5392, August 2005)

Using the proper service pack with the SSSU
Ensure that the required service pack is installed if you are using sssunlm.nlm on Novell NetWare.
Otherwise, a critical failure occurs on the second run. See Table 1 for a list of the appropriate Novell
NetWare service packs.
Using snapshot or snapclone
When you create a snapshot or snapclone with Novell NetWare, you must present the snapshot or
snapclone to a host other than that host from which is was created. You cannot access a snapshot or
snapclone from the same host from which it was created.
For example, suppose you have a unit presented on NetWare Host A and you make a snapshot or
snapclone of it and present this new unit to the same host (Host A), NetWare perceives a conflict.
Because the new unit is identical to an existing unit, the host assumes that the two units are a broken
software mirrorset. NetWare deactivates both devices and informs you that there is a possible broken
mirrorset. To access the new unit, present it to a different host from which the snapshot or snapclone
was created.
You may also choose to present the snapshot or snapclone to a host at a later time, or not at all.
6