HP StorageWorks HP-UX Kit V3.0B for Enterprise Virtual Array Installation and Configuration Guide (AA-RUHKB-TE, October 2003)

Installing the HP-UX Kit
26 HP-UX Kit V3.0B for Enterprise Virtual Array Installation and Configuration Guide
As your system starts up, startup information is logged in a file called syslog.log
(/var/adm/syslog/syslog.log) where, among many other items, versions of the
installed FCA drivers are recorded.
1. To view the installed products, type the following:
# swlist -l product A6795A
2. Inspect the latest entry line for the FCA driver.
The following is an example:
A6795AB.11.00.10PCI Tachyon TL/TS/XL2 Fibre Channel
A6795A.FC-TACHYON-TLB.11.00.10PCI Tachyon TL/TS/XL2 Fibre
Channel
3. Ensure that you have the correct driver version for each of your FCAs. Check
the release notes included in this kit for the supported versions of driver and
patch levels required in order for your system to operate properly.
If your driver version is not at minimum revision or above, you should see the
HP website for the operating system, FCA driver, and patch versions.
Updating the HP-UX Driver
The driver version is dependent on the operating system version. Check the
release notes that came with this kit for the most up-to-date versions of
operating systems, FCAs, and drivers.