HP StorageWorks Enterprise Virtual Array 3000/5000 updating product software guide (VCS 3.110) (5697-7959, February 2009)

• HP StorageWorks Command View EVA

• HP StorageWorks Command View EVA Performance Monitor

•HPStorageWorksSMI-SEVA

•HPStorageWorksSMI-SCIMOM

NOTE:

HP Storage System Scripting Utility is not listed in Add/Remove P rograms.

2. Run HP Command View EVA.

3. Verify the display of storage system resources in the interface. In the Navigation pane, click

Hardware and verify the following:

• N ew, uninitialized arrays appear as uninitialized storage systems.

• P reviously initialized arrays appear with their previous names and correct status. (Select each

storagearraytoviewthePropertieswindow.)

• Previous disk groups, hosts, virtual disks, and other resourc es appear in the N avigation pane.

If information is not displayed properly, it may be necessary to conﬁgure your browser settings. See HP

StorageWorks Command View EVA installation guide for more information.

Upgrading browsers and JRE (Optional)

Estimated time to complete: 10–20minutes

When to perform: Any time prior to the upgrade

If you are running HP Command View EVA 5.x or 6.x, you do not need to perform this task.

Ensure that you are using a supported browser and JRE. HP Command View EVA may not work correctly

with an unsuppor ted browser.

TheJREisnotusedbyHPCommandViewEVA,butitisneededforHPReplica-

tion Solutions Manag er. It is also required for WEBES and SAN Visibility. See

“Upgrading HP Replication Solutions Manager (optional)” on page 40 for more information.

For complete information on supported browsers and JREs, see the "Browsers and JRE support" table in

the HP StorageWorks EVA soft ware compatibility reference.See“Required documentation” on page 14

for the link to this document.

NOTE:

If you need to update the browser version on remote computers, do so after you have upgraded HP

Command View EVA.

Upgrading to WEBES 4.5 RU1(Optional)

Estimat

ed time to complete: 10–20 minutes

When to perform: Any time prior to the upgrade

WEBES is optional diagnostic monitoring software. If WEBES is currently installed, it must be upgraded to

version 4.5 RU1, which is required with HP Command View EVA 6.0 or later. To download the WEBES

4.5 RU1

software kit, go to the following web site:

ttp:/

/h18023.www1.hp.com/support/svctools/webes/

Pre-upgrade tasks