HP StorageWorks 3000/5000 Enterprise Virtual Array updating product software guide (VCS 4.100) (5697-7055, November 2007)

Figure 19 Enable Password Access to a Storage System page
5. Select the World Wide Node Name of the storage system for which you want to enable password
access.
6. Type the password in the Password and Confirm password fields.
NOTE:
Make sure you use the same password you entered into the HSV controller OCP.
7. Click Enable Password.
A message box opens.
8. Click OK.
HP Command View EVA enables password access to the storage system.
Step 8. Resuming storage system operation
Estimated time to complete: 30 minutes
After the storage system software and disk fir
mwarehavebeensuccessfullyupgraded,thestoragesystem
can b e returned to normal operation.
1. Using Command View EVA, check the overall status of the storage system to
ensure there are no problems. For instructi
ons on checking the status, see
“Step 1. Checking the hea lth of the Enterpri
se Virtual Array” on page 24 .
2. If you performed an offline upgrade, restar
t any host servers that were shutdown for the upgrade.
Restart applications accessing the storage system.
3. Enable SNMP if necessary.
4. If you are running ISEE, enable it as follows:
a. Save and clean application eventlog file.
b. On the m anag ement server, open a command window.
c. Enter the following command to start ISEE:
C:\>DESTA ISEE ON
d. Enter the following commands to stop and restart WEBES:
C:\>net stop desta_service
C:\>net start desta_service
HP StorageWorks 3000/5000 Enterprise Virtual Array updating product software guide (VCS 4.100)
39