HP StorageWorks 3000/5000 Enterprise Virtual Array updating product software guide (VCS 3.110) (5697-8108, March 2009)

9. When all the disk drives have been upgraded, the Code Load Disk Drives On Line - Page 3
window opens indicating the drives that have been upgraded successfully. Click Finish.
Figure 28 Code Load Disk Drives — Page 3 window
Upgrading firmware on an individual disk
If it is necessary to upgrade the firmware on an individual disk, the firmware and installation instructions
can be downloaded from the following web site:
http://www.hp.com/support/evadiskfirmware
Step 7. Entering storage system passwords
Estimated time to complete: 10–15 minutes
NOTE:
• This step is only required if you use password protection on the storage system.
• When you add a system password to the controller, you must also enable password access in HP
Command View EVA. The two work in conjunction with one another.
Enter a unique eight-character password using uppercase or lowercase letters A through Z.
Entering the password on the OCP
Using the following procedure to enter the password on the storage system controllers. The password
can be entered from either controller.
1. With either of the default menus (Storage System Name or World Wide Name) displayed, press
three times to display System Password.
Upgrading the Enterprise Virtual Array52