HP StorageWorks 3000/5000 Enterprise Virtual Array connectivity for Novell NetWare installation and reference guide (5697-7042, November 2007)

3. Select a LUN number if you chose a specific LUN on the Virtual Disk Properties page.
4. Restart the server or rescan the bus.
Verifying virtual disks from the host
This section d escribes how to verify that operating system hosts can access the virtual disks created on the
Enterprise Virtual Array with HP Command View EVA. The host can recognize Enterprise Virtual Array
devices eithe
r through a system restart or by rescanning the bus.
With Novell Ne
tWare, if you choose not to restart the operating system, you must manually scan for all
new devices an
d all LU N s. To manually scan for devices and LUNs, enter the following commands:
Scan for new devices
Scan all LUNs
List devices
If you are unable to access the virtual disk, check the following:
• Verify all cabling to the switch, Enterprise Virtua l Array, and host.
• Verify all fir
mware levels (check the associated Enterprise Virtual Array release notes for details).
• Ensure that you are running a supported version of the host operating system.
• Ensure that the correct host is selected for this virtual disk in the HP Command View EVA.
• Che ck whethe
r the zones (if any) are configured properly on the SAN switch.
Configuring virtual disks from the host
After you set up the virtual disks on the Enterprise Virtual Array and have rescanned or restarted the host,
follow the host-speci fic conventions for configuring these new disk resources. Refer to the documentation
that came with your server for specific instructions on setting up disk resources.
12
Testing connections to the Enterprise Virtual Array