HP StorageWorks 3000/5000 Enterprise Virtual Array Connectivity 3.1A for Novell NetWare Release Notes (5697-6382, June 2007)

Changing the name of a disk enclosure
Changing the name of a disk enclosure is not supported with the SSSU or with Command View EVA. If
you try to change a disk enclosure name using SSSU, the following error message appears:
Error: Invalid Operation
Using the proper service pack with the SSSU
Ensure that the required service pack is installed if you are using sssunlm.nlm on Novell NetWare.
Otherwise, a critical failure occurs on the second run. See Table 1 for a list of the appropriate Novell
NetWare service packs.
Using snapshots and snapclones
When you cre ate a snapshot or snapclone with N ovell NetWare, you must present the s napshot or
snapclone to
a host other than that host from which is was created. You cannot access a snapshot or
snapclone from the sa me host from which it was created.
For example, suppose you have a unit presented on N etWare H ost A and you make a snapshot or
snapclone of
it and present this new unit to the same host (Host A), NetWare perceives a conflict. Because
the new unit is identical to an existing unit, the host assumes that the two units are a broken software
mirrorset. NetWare deactivates both devices and informs you that there i s a possible broken m irrorset. To
access the new unit, present it to a different host from which the snapshot or snapclone was created.
You may also
choose to present the snapshot or snapclone to a host at a later time, or not at all.
HP StorageWorks 3000/5000 Enterprise Virtual Array conn ectivity 3.1A for Novell NetWare release notes
5