Brocade Fabric OS Encryption Administrator's Guide v6.3.0 (53-1001341-02, July 2009)

Encryption Administrator’s Guide 37
53-1001341-02
Creating a new encryption group
2
Creating a new encryption group
The following steps describe how to start and run the encryption setup wizard, and then create a
new encryption group.
NOTE
When a new encryption group is created, any existing tape pools in the switch are removed.
1. Select Configure > Encryption from the menu bar.
The Encryption Center dialog box displays.
FIGURE 18 Encryption Center - No Group Defined dialog box
2. Select a switch from the <NO GROUP DEFINED> encryption group. The switch must not be in
an encryption group already.
3. Select Switch > Create/Add to Group, or right-click the switch and select Create/Add to Group.
The Configure Switch Encryption welcome panel displays.