Brocade Fabric OS Encryption Administrator's Guide v6.3.0 (53-1001341-02, July 2009)

Encryption Administrator’s Guide 25
53-1001341-02
Viewing and editing group properties
2
Viewing and editing group properties
To view encryption group properties, complete the following steps.
1. Select Configure > Encryption.
The Encryption Center dialog box displays.
2. If groups are not visible in the Encryption Devices table, select View > Groups from the menu
bar.
The encryption groups display in the Encryption Devices table.
3. Select a group from the Encryption Devices table, and select Group > Properties from the
menu bar, or right-click the group and select Properties.
The Encryption Group Properties dialog box, shown in Figure 7, has six tabs which are defined
in this section:
• “General tab” on page 26
• “Members tab” on page 26
• “Security tab” on page 29
• “HA Clusters tab” on page 29
• “Engine Operations tab” on page 30
• “Link Keys tab” on page 31
• “Tape Pools tab” on page 32
NOTE
The Link Keys tab appears only if the key vault type is NetApp LKM.
FIGURE 8 Encryption Group Properties dialog box