Brocade Fabric OS Encryption Administrator's Guide v6.3.0 (53-1001341-02, July 2009)

Encryption Administrator’s Guide 105
53-1001341-02
CryptoTarget container configuration
3
4. Create a zone that includes the initiator and a LUN target. Enter the zonecreate command
followed by a zone name, the initiator PWWN and the target PWWN.
FabricAdmin:switch>zonecreate itzone, "10:00:00:00:c9:2b:c9:3a; \
20:0c:00:06:2b:0f:72:6d"
5. Create a zone configuration that includes the zone you created in step 4. Enter the cfgcreate
command followed by a configuration name and the zone member name.
FabricAdmin:switch>cfgcreate itcfg, itzone
6. Enable the zone configuration.
FabricAdmin:switch>cfgenable itcfg
You are about to enable a new zoning configuration.
This action will replace the old zoning configuration with the
current configuration selected.
Do you want to enable 'itcfg' configuration (yes, y, no, n): [no] y
zone config"itcfg" is in effect
Updating flash ...
Creating a CryptoTarget container
1. Log into the group leader as Admin or FabricAdmin.
2. Enter the cryptocfg
--create -container command. Specify the type of the container, (disk or
tape), followed by a name for the CryptoTarget container, the encryption engine’s node WWN,
and the target’s Port WWN and node WWN. Provide a slot number if the encryption engine is a
blade.
• The CryptoTarget container name can be up to 31 characters in length and may include
any alphanumeric characters, hyphens, and underscore characters.
• You may add initiators at this point or after you create the container.
The following example creates a disk container named my_disk_tgt1. The initiator is added in
step 3.
FabricAdmin:switch>cryptocfg --create -container disk my_disk_tgt \
10:00:00:00:05:1e:41:9a:7e 20:0c:00:06:2b:0f:72:6d 20:00:00:06:2b:0f:72:6d
Operation Succeeded
3. Add an initiator to the CryptoTarget container. Enter the cryptocfg --add -initiator command
followed by the initiator port WWN and the node WWN.
Note that the initiator port WWN must also be added to the LUN when the LUN is added to the
CryptoTarget container.
FabricAdmin:switch>cryptocfg --add -initiator my_disk_tgt \
10:00:00:00:c9:2b:c9:3a 20:00:00:00:c9:2b:c9:3a
Operation Succeeded
4. Commit the transaction. The commit operation creates the virtual devices and the redirection
zone that routes traffic through these devices.
FabricAdmin:switch>cryptocfg --commit
Operation Succeeded